Get Help


OctoPrint crashed with 50 layers left on a 3 day print. :( [Get Help] (20)
Creating a master Octoprint install [Get Help] (7)
Print issue only with octoprint [Get Help] (2)
Print stops randomly [Get Help] (3)
Sjcam 5000 working with octoprint? [Get Help] (2)
Octopint connects to printer and detects firmware but cannot quite control it [Get Help] (7)
Print automatically restarts (printing from Cura plugin) [Get Help] (2)
M226 Pause Gcode ignored [Get Help] (5)
X/Y axes both half an inch off [Get Help] (2)
Ability to start loaded print from LCD [Get Help] (2)
_psposix.py file has EOL issue [Get Help] (5)
Show end (date and) time instead of duration [Get Help] (2)
Filamentsensor not detected [Get Help] (2)
OctoPi to Lerdge S board [Get Help] (5)
Configuration of a wifi camera [Get Help] (14)
Printer(s) hang mid print [Get Help] (4)
How to connect Octoprint by serial port i2c with Raspi 3 B (Raspbian)? [Get Help] (6)
Octoprint sets target temp 7454c [Get Help] (5)
Print Job auto-repeating and destroying completed print (printing from Cura plugin) [Get Help] (6)
WIFI Not connecting on Octopi (latest release) [Get Help] (4)
Connecting octoprint to Creality CR10S4 trips out the printer ( 2 ) [Get Help] (31)
Cannot Connect to Octoprint Anymore [Get Help] (3)
Octoprint not booting, Kernel Panic [Get Help] (13)
Octopi 0.15 and running 2 printers with one Raspberry pi [Get Help] (5)
Print resumes before "resume" button is pushed [Get Help] (3)
Octoprint not sending G2/G3 [Get Help] (7)
Remote Pre-Printing Placement Sequence Extremely Slow [Get Help] (5)
Thermal Runaway Protection absent on Creality Ender 3 [Get Help] (11)
Reverse proxy configuration examples [Guides] (1)
Solution - Date/Time on timelapse [Get Help] (8)